Howto Hardware Factory Reset

From berofix - professional SIP gateway

Jump to: navigation, search

This Howto describes how to do a factory reset on a berofix device. This could be useful in case of a lost password or in any case where you lost the connection to the berofix device. This Feature works only with Firmware Version > 1.12 and FPGA image Version >= 3. The Hardware Factory Reset deletes all data on the berofix device incl. the firmware and restores the default values. There are 8 steps howto initiate the Hardware Factory Reset.

  • 1. Power off the card/device.
  • 2. In case of a card remove the card from your computer. In case of a Box check if you can access the PCM connector on the rear from the outside, otherwise open the box.
  • 3. Short the two Pins horizontal with a Jumper ( the yellow marked rectangle see Picture below).

Image:Bf_HWReset1.png

  • 4. In case of a Box Power up the device or in case of a card plug the card in your computer and power up the device.
  • 5. After you power up the device the berofix should be reachable again with the default IP address 10.0.0.2. Open your Browser with this new address and wait until you get a response from the berofix (this could take a couple of minutes. see picture below).

Image:Bf_HWReset2.png

  • 6. Upload a new Firmware (see picture above).
  • 7. Install the new Firmware (see picture below).

Image:Bf_HWReset3.png

  • 7. Power Down the device and remove the Jumper.
  • 8. Power Up the device. The device is now Ready with factory defaults.
Retrieved from "http://www.beronet.biz/index.php/Howto_Hardware_Factory_Reset"
Personal tools